seagate backup plus not recognized windows 10

I recently realized that I have a switch configuration with an unintended potential side-effect.I have an Aruba 6300F with several VLANs on it.

Can I plug the mgmt interface of a switch into one of its own switch ports? Networking.What could an IT Pro do with superpowers? Which IT tasks would you use them in and how? Which Superpowers Would You Like to Have? Water Cooler.NTFS Volume Serial Number : 0x784aa9a34aa95f1e NTFS Volume Serial Number : 0xdeb0e591b0e57087 If you manage to result this please let me know. It seems that Seagate is using this situation to their advantage to sell areas of their 'DiszWizard' tool for Idea use. I'm on the hunt for an Advanced Formatter to fix this issue. Windows '512-byte Emulation (512e)' doesn't even help with this as that is installed. It needs to be '512' for Windows to support it. Note where it says, 'Bytes Per Physical Sector'.

However, if I run it on the same model drive, just older (and works) it gives me the the secon set of results below. If I run this command (change x for the drive letter) 'fsutil fsinfo ntfsinfo x:', On a working drive (same model) give me the results of the 1st set of results below. So Windows Server Backup can see the drive, sort of, but can't add it as a destination. Then when I pick it and click OK, it doesn't snow up on the list 'Select Destination Drive' I tried again to add the drive as a backup destination. I can select it in 'Show all available drives', but it shows on the list as 'Unmounted'. (A device which does not exist was specified.) Corruption may occur in VolumeId: ?, DeviceName. The system failed to flush data to the transaction log. It tried reformatting manually it from Server Manager with default settings for NTFS, not sure what happened, no response in the gui, but event manager showed: Now the drive has a new volume label courtesy of Windows Backup and is invisible from Windows Explorer. It started formatting the first drive and died with : 'Formatting the disk has failed - The parameter is incorrect' (Thanks, Bill for that wonderful error message.) Tried adding these drives as additional destinations to my existing backup job. I've been using the card successfully with WD drives until I started seeing disk errors on one of the drives, so decided to replace them both with the Seagate drives. Running the drives from an add on controller card that supports USB 3.0. I just got 2 new Seagate Backup Plus Desktop Drive Model SRD00F2 P/N 1KBAP3-500 4TB.

Seagate backup plus not recognized windows 10